Getting close :)

[CiKoTiC]

Almost there AI :biggrin:

[CiKoTiC]

Oh yea... 8)

[Jason425]

i just did 3dmark 03.. 2808.. and didnt one of you guys get like 5k? something sure is off beat on my comp.. and that shooter test lags more than it should.. :cry:

[BobyJo]

I just downloaded 3dmark03 and thought the score I did was terrible, maybe it is not as bad as I thought.

http://service.futuremark.com/compare?2k3=325035

Have not had a chance to get to 3dMark2001se as yet. Cause I had a hard drive go up in flames a couple days ago. Man I would like my files and stuff off that drive @$$%$. NEVER a Maxtor HD again for me.

[accurateimage]

Oh yeah man coo :) now just have to break 18133 :) telling ya you should have listened to me, I run a $95 chip, and an oem vid card I paid $270 for out the door and I still score this high *LOL* You could have saved enough cash to build another pc by not bying that barton or that expensive vid card!

[CiKoTiC]

hehe.. but that's no fun AI. Knowing what works takes the exceitment out of it. :P

I put a Zalman Heat pipe on my vid card along with some ram sinks. I also added a Delta fan and converted a P4 HS fan and stuck that on it.

Mem didn't really go up but the core went up to about 390 from 371 but somewhere I lost some stability. I think the one fans that's hooked up to the mobo is what is causing it. I was able to run at 204 FSB with 2,2,3,5 mem timings but now I can't get it above 200FSB even if I lower the timings. If I can find a 3 pin to molex adapter, I'll be able to test it out.

[eviltechie]

i would never plug a vantec tornado or a delta onto the mobo

the drain is too big
i remember globalwin's manual said not to plug it directly onto mobo's 3 pin too

so yeah
you have to find that adaptor fast!

[CiKoTiC]

Actually the delta is not the one plugged into the mobo. The P4 fan is.

I'm stumped right now as to the reason I can't do 204 FSB as before. The only thing I've done is add the extra cooling to the vid card.