TMD fan's - pretty interesting

i just posted in hardware board

btw, while i posted i had options to post sticky and announcement, for a sec i though i had been given mod status , i think you need to check the permissions in board control for the hardware board as normal users have some extra options they shouldn't

Originally Posted by vee_ess

Well, fan adapters give you one or the other. If you are running a low performance fan, the noise won't increase, but it will push out more air; if you are running a high performance fan, the noise will decrease, but it will put out as much air. This is because you are running a given amount of air through the smaller hole size, except it is eased into the increased pressure (vs. larger hole). I would just suggest getting out the Dremel and increasing the hole. Heck, just put a window in while your at it.

vee...I seem to be getting mixed signals...or I am just plain slow. At first it apprears that you are talking about a fan adapter on the heatsink for your processor...and later you seem to be talking about a blow hole. I am concerned with the heatsink on the processor...fan adapter...putting a bigger fan on with lower decibel, but higher or equal CFM

[vee_ess]