2 WIN98SE in 2 HD's !!

HI.

I have WIN98SE in my Hard-Disk .
I connected another Hard-Disk as SECONDARY, and it has WIN98SE too .

The FIRST HD is "C"
The Second HD (the secondary) is "D"

Everytime I run my computer.. the WIN98SE which is in the FIRST HD
is loaded !!

What I have to do inorder to tell my computer to run WIN98SE which
is in my SECOND HD ??

[Uranium-235]

I'm not sure which bios you have. But it's in your cmos setup. Look for something like "first boot device"

and One should say like HD0 or HDD-0, set it ti HDD-1 or whatever your second hard drive is on the chain

Just switch the Hard drives on the IDE cable. Make the drive with 98se you want to boot from the master.

if u switch the HD's make sure u set the correct jumper settings.

just incase

or download a bootloader