|Form Factor||ATX Mid Tower|
|Color / Type||Black (Steel)|
|Front Bezel Material||Mesh|
|Motherboard Support||ATX / MicroATX|
|USB 2.0 / 3.0||2 / 2 (Top Panel)|
|HD/97 Audio||Yes (Top Panel)|
|Included Fans||2 (120mm Rear; Front LED)|
|Optional Fans||Up to FOUR (5) 120mm additional fans|
|Dimensions (Chassis)||205(W) x 460(L) x 430(H) MM|
|Weight||11.2 lbs / 5.1kg|
|Left side||Right Side|
The Ravager comes with a set of unique decals which grabs your attention. The left side has the claw marks covering most of the side of the case stopping short of the two exhaust fan ports. The right side of the case does have a small corner of the panel with the claw mark paint scheme, but leaves the rest of the panel looking a little plain.
|The top panel comes with two USB 2.0 and two USB 3.0, Audio, MIC ports reset button and HDD LED||The remaining top of the case has an area for additional fans if desired.|
The top I/O panel comes with two USB 2.0 and two 3.0 ports which by themselves are a welcomed site but the gap around the plugs seemed a little excessive. This space around the actual port did not detract from the strength of the ports, but was noticeable. The reset button is a little tiny and we figured we would rather have it on the front of the case near the power button along with the HDD LED. The audio ports were nicely located on the top as well, which makes you think this case should be placed on the floor, rather than on your desk.