Techwarelabs Community

Page 1 of 2

Show 40 post(s) from this thread on one page

Techwarelabs Community (https://www.techwarelabs.com/community/index.php)

- General Board (https://www.techwarelabs.com/community/forumdisplay.php?f=7)

- - help! (https://www.techwarelabs.com/community/showthread.php?t=1994)

XDiGiTaLX

09-01-2002 03:23 AM

help!

does anyone know why my dremel does a hisssing noise when i set the speed to zero after turning it on...

i'm guessing it needs to be lubed... whts ur guess?

eviltechie

09-01-2002 03:48 AM

it definately needs to be lubed

check for dusts or particles that might get into it...

MIK3	09-01-2002 04:18 AM

or another defect might be that one of the gears are slightly stripped...you might wanna take it apart and examine the inside

Smoked1

09-02-2002 04:13 AM

There should be a warranty on iy unless you VOIDED it.

eviltechie

09-02-2002 12:45 PM

LOL!!

ModNoob

09-03-2002 10:30 PM

classic..smoke, thats classic

Smoked1

09-03-2002 11:10 PM

LOL

Grinnin Reaper

09-04-2002 07:47 AM

How to mod your mod tools. Sounds like a nice new section whatta ya think Smoked? Pop out that puny motor in the dremel squeeze a RC car motor in there that tops out about 30,000 rpm and add one helluva battery back. And a window, don't forget the window.

Smoked1

09-04-2002 09:04 AM

Not to mention paint

Grinnin Reaper

09-04-2002 07:23 PM

So what are you thinking of, flame job or a motto? "Death to all warranties, expressed or implied"

All times are GMT -5. The time now is 10:53 AM.

Page 1 of 2

Show 40 post(s) from this thread on one page