![]() |
2 WIN98SE in 2 HD's !!
HI.
I have WIN98SE in my Hard-Disk . I connected another Hard-Disk as SECONDARY, and it has WIN98SE too . The FIRST HD is "C" The Second HD (the secondary) is "D" Everytime I run my computer.. the WIN98SE which is in the FIRST HD is loaded !! What I have to do inorder to tell my computer to run WIN98SE which is in my SECOND HD ?? |
I'm not sure which bios you have. But it's in your cmos setup. Look for something like "first boot device"
and One should say like HD0 or HDD-0, set it ti HDD-1 or whatever your second hard drive is on the chain |
Just switch the Hard drives on the IDE cable. Make the drive with 98se you want to boot from the master.
|
if u switch the HD's make sure u set the correct jumper settings. :biggrin:
just incase |
or download a bootloader
|
All times are GMT -5. The time now is 01:47 AM. |
Powered by vBulletin® Version 3.6.5
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.