Also wanted to say that enermax powersupply I bought was worth every penny, It has a rear adjustable 80mm fan and a 92mm clear non adjustable, they rated the 80mm fan at only 3,000 rpm max and I see a whopping 4688 rpm! Kinda understated don't ya think..?? Also the 92mm sits right over my heat pipe sink about 3 inches so all of the warm air is drawn right up and out, my chip temp dropped from a absolute max of 107-108 running seti to 103-104 and have not seen a degree higher! Very awsome placement in the antec case and very awsome product, so far I give it 9 out of 10 skirts up for I noticed the instruction manual was seriously lacking for the extra function on the supply, was easy to figure out but joe smo that is just replacing a powersupply for the first time and jumps into it will find it very hard to understand and figure out were he control wires go and stuff like that, wires were extra long and fit tight with no loose connections. Again 9 OUT of 10 skirts up on this product baby! The model # is EG465P-VE(FCA)