Molex connector

What's the best way to remove the pins from a molex connector?

Tie the wire to your bumper, and put the molex in a vise, get in the car and floor it works every time!

there is something called the molex pin extractor

saw it at our twl's case clean up article

http://www.techwarelabs.com/guides/misc/wire_cleanup/



here is a place that sells it
http://www.tecratools.com/pages/datacom/extraction.html

not cheap...
this place has a more economical one
http://www.ba-electronics.com/molex.htm

I just use a threading needle to get the connectors out of the housing.