SiSoftware Sandra

Benchmark Results
Combined Index : 9108 MB/s
Speed Factor : 9.6
2kB Blocks : 27953 MB/s
4kB Blocks : 26681 MB/s
8kB Blocks : 26589 MB/s
16kB Blocks : 24524 MB/s
32kB Blocks : 20411 MB/s
64kB Blocks : 20992 MB/s
128kB Blocks : 21099 MB/s
256kB Blocks : 21058 MB/s
512kB Blocks : 20348 MB/s
1MB Blocks : 18619 MB/s
4MB Blocks : 2929 MB/s
16MB Blocks : 2924 MB/s
64MB Blocks : 2924 MB/s
256MB Blocks : 2919 MB/s
Results Interpretation : Higher index values are better.

Float SSE2 Cache/Memory Results Breakdown
Data Item Size : 16 byte(s)
Buffering Used : No
Offset Displacement Used : Yes

Performance Test Status
Run ID : WEBSOFT-TEST on Saturday, 3 September 2005 at 5:39:45 PM
NUMA Support : No
SMP Test : No
Total Test Threads : 1
Multi-Core Test : No
SMT Test : Yes
Dynamic MP/MT Load Balance : No
Processor Affinity : P0C0T0 
Page Size : 4kB
Use Large Memory Pages : No

Processor
Model : Intel(R) Pentium(R) 4 CPU 3.00GHz
Speed : 3.00GHz
Performance Rating : PR3990 (estimated)
Cores per Processor : 1 Unit(s)
Internal Data Cache : 16kB Synchronous, Write-Thru, 8-way set, 64 byte line size, 2 threads sharing
L2 On-board Cache : 1MB ECC Synchronous, ATC, 8-way set, 64 byte line size, 2 lines per sector, 2 threads sharing

Features
SSE Technology : Yes
SSE2 Technology : Yes
SSE3 Technology : Yes
HTT - Hyper-Threading Technology : Yes

Chipset 1
Model : Intel Corporation 82875P,E7210 Memory Controller Hub
Front Side Bus Speed : 4x 200MHz (800MHz data rate)
Width : 64-bit
Maximum Bus Bandwidth : 6400MB/s (estimated)

Logical/Chipset 1 Memory Banks
Bank 0 : 512MB DDR-SDRAM 2.0-2-2-5 1CMD
Bank 1 : 512MB DDR-SDRAM 2.0-2-2-5 1CMD
Channels : 2
Speed : 2x 200MHz (400MHz data rate)
Width : 64-bit
Performance Acceleration Technology : Yes
Maximum Memory Bus Bandwidth : 6400MB/s (estimated)

Performance Tips
Notice 5008 : To change benchmarks, click Options.
Notice 5004 : Synthetic benchmark. May not tally with 'real-life' performance.
Notice 5006 : Only compare the results with ones obtained using the same version!
Tip 11 : Use the 'Switch Chart Type' button to switch between Detailed and Combined charts.
Tip 2 : Double-click tip or press Enter while a tip is selected for more information about the tip.