|
Corsair Survivor 32GB Flash Drive
Benchmarking:
HD Tune Pro 3.00 was run on the drive three times for read speeds - the graphs are shown below. The average for the read speed was 21.8MB/sec.
(click the thumbnails to enlarge)
 |
 |
 |
average read speed: |
average read speed: 21.7 MB/sec |
average read speed: 21.8 MB/sec |
We then ran CrystalDiskMark on the Survivor four times - the graphs are shown below. The average read speed was 23.68 MB/sec.
(click the thumbnails to enlarge)
 |
 |
average read speed @ 50MB: |
average read speed @ 100MB: 23.69 MB/sec |
 |
 |
average read speed @ 500MB: |
average read speed @ 1000MB: 23.69 MB/sec |
SiSoft Sandra was run on the drive to test the operations per minute and endurance factor. The results are shown below:
(click the thumbnails to enlarge)
 |
SiSoft Sandra: |
Since the Survivor flash drive is not an actual disk, we ran HD Tach 3.0.1.0 for the mere sake of testing the burst speed and CPU utilization. The burst speed was recorded to be 24.4MB/sec.
(click the thumbnails to enlarge)
 |
HD Tach 3.0.1.0 |
Analysis:
The average read speed between the benchmarks came out to 23.3 MB/sec, which is not bad for a high capacity flash device such as this. The write speed came out to an average of 8.36 MB/sec, which isn't horrible either. According to HD Tach, CPU utilization was only 6%, which causes a nearly unnoticeable change in your PC's performance.
Real Time Pricing: