new case for system build

[gotrootdude]

Here's mine, I've just spent a few hours on it so far. My original plan for using a clear PS fell through the cracks, it just didn't look right. So, I swapped it with a black Antec and haven't had time to shorten and loom the wires. I'm going to have to swap out the heatsink for a Artic Silencer 64. The mislabled case headers threw me for a loop, I thought the switch was bad, so I took it off the front to check it.

Anyway, the case looks much better assembled and running than the picture gives it credit for. I'll finish it in another week or two, since I only get a short period of time to work on it during the weekends. Plus, my camera is a $20 piece of junk.


Beware, this case is under heavy construction. Nowhere near completion. I also plan on adding some toggle switches to the unused 3 1/2 bay, meaning I'll have to drill out the plastic. Since I don't have the correct drill bits, I'll be using a sizing guide with a dremel and a engraving attachment for the work.