|
|
 |
| Kingston HyperX 2GB DDR3-1600 RAM kit |
|
Kingston HyperX 2GB DDR3-1600 RAM kit
Today's computers require the highest in RAM speeds and capacity. If their 1375MHz kit isn't fast enough for you, Kingston presents their new KHX12800D3K2/2G DDR3 1600MHz 2GB kit. With its low profile and sleek blue side panels, it will keep your computer looking hot, while running cool.
Kingston's Take:
"It's Here — HyperX DDR3 memory, the next-generation evolution of DDR memory technology. Like all Kingston HyperX products, HyperX DDR3 modules are specifically engineered and designed to meet the rigorous requirements of PC enthusiasts. HyperX DDR3 offers faster speeds, lower latencies, higher data bandwidths and lower power consumption. HyperX is available in single and dual-channel memory kits."
Features:
- 1.7 Volts operation
- Memory signal termination inside the memory chip (On-Die Termination) to prevent reflected signal transmission errors
- Operational enhancements to increase memory performance, efficiency and timing margins
- CAS Latencies: 5 (Ultra Low Latency) and 7 (Low Latency)
- Currently available in speeds up to 1.5GHz and capacities up to 2GB kits
- DDR3 memory modules are not backward compatible to DDR2 and DDR based motherboards, due to incompatible module connections (number of pins), voltage and DRAM technology. DDR3 memory modules have a different key or notch than the same-sized DDR and DDR2 modules to prevent their insertion into an incompatible memory socket. HyperX is available in single and dual-channel memory kits.
Specifications:
- JEDEC standard 1.5V ± 0.075V Power Supply
- VDDQ = 1.5V ± 0.075V
- 533MHz fCK for 1066Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 6,7,8,9,10
- Posted CAS
- Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
- Programmable CAS Write Latency(CWL) = 7(DDR3-1066)
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
- Asynchronous Reset
- 1066Mbps CL7 doesn’t have backward compatibility with 800Mbps CL5
- PCB : Height 1.180” (30.00mm), double sided component
Real Time Pricing:
|
|
|
