Crystal Mark:
CrystalMark is a total system benchmark that tests your CPU, memory, hard drive, and graphics. As the results alone don’t mean much and are hard to understand, it’s a good tool to compare full systems. Shown below you can clearly see the overall results for each of the systems.
 |
All the tests came out fairly high in the scoring. The HDD obviously was no help to the overall score. However, the CPU testing all posted much higher than I had anticipated.
Kribi Bench:
Kribi Bench is a software renderer which renders a 3D Model and reports the average frames per second. “The essential task in the final phase of the development of a 3D rendering engine, much like for a racing car engine, is tuning for the best possible performances on actual machines. After each small change in the program code, very precise timings show us the amount of speedup achieved (if any). For this purpose, we time with a stopwatch the rendering of a sequence of images, the laps of our racecourse. “
For this test the models ultra.d and spongeexplo.d were used because they came with Kribi. Ultra.d posted an average FPS of 4.74 while spongeexplo.d posted an average FPS of 16.56.
 |
 |
| model – ultra.d | model – spongeexplo.d |
This might be off topic but I have just fInished assembling a new RIG using the nf980-g65 MB. Have checked all the connections the board lights up all fans run GPU CPU Case etc. The blue APS light is on. The DVD drive is live at least the drawer opens and closes and the green light comes on and goes off as it should. Not so sure about the HDD. How do I check that? Not getting any beeps. Not sure if this board has a speaker? Can’t find any built in the case either. Anyhow to get to the point I do not get a post screen. Can’t install OS or MB drivers. The lights are on but nobody’s home.
NF980-G65
Phenom ll x4 965 Black
4gb DDR3 CL9 Kingston 1333mhz
MSI N465GTX (OC to 470 Specs)
PSU OCZGXS850
500 gb SATA ll Seagate HDD
Sony DVD
Well first unplug everything but the power connections,CPU,RAM. I assume you are using aftermarket vid or onboard vid. Make sure the power to the vid is plugged in right. Then start. if that doesnt work, post back here and we can go to the next step.
Hi Jason
Thanks for your input. I did what you said and it booted to post. Now I’m just tweaking everything up. For a while I thought a piece of hardware or a short at the MB / Case was at fault and I would have to start from scratch again. But as it happened I disconnected all the hardware pulled the ram and moved one stick to another channel and away it went. So thanks for help.
Ron
This may be a dead subject…but after having this board for months it has started not posting. I have to turn the power on….wait a few seconds then hit the reset button…sometimes 2-3 times before it posts….sooo frustrating.
Finally I just bought the crosshair extreme. Im in a jam because I have the AMD 1090T and two GTX580’s…tough to find an AMD board that supports SLI.
here is my rig http://www.youtube.com/watch?v=35g_mnlG0ME
How is this board still running for you? I have heard that it has its faults and quite a few of them actually POP* and generate smoke/sparks when overclocked.