Cinebench:
MAXON CINEBENCH runs several tests on computers to measure the performance of the processor and graphics card under real-world circumstances and makes use of up to 16 cpu’s or cpu cores. Cinebench’s test process is in two-phases: The first test procedure is directed against the cpu using a 3D render scene and photo realistic image settings shown above to test how fast the cpu can produce the fully rendered scene. During the 1st pass of the test, the benchmark will only use one cpu, or in a multi-core/cpu system it will use only a single cpu core to render the photo realistic scene to get a base value against which it will then perform the 2nd phase of the test using all of the cpu cores available. Higher Frames/Second and lower rendering time in seconds equals better performance. Lets see how the testing for Cinebench went:
 |
This might be off topic but I have just fInished assembling a new RIG using the nf980-g65 MB. Have checked all the connections the board lights up all fans run GPU CPU Case etc. The blue APS light is on. The DVD drive is live at least the drawer opens and closes and the green light comes on and goes off as it should. Not so sure about the HDD. How do I check that? Not getting any beeps. Not sure if this board has a speaker? Can’t find any built in the case either. Anyhow to get to the point I do not get a post screen. Can’t install OS or MB drivers. The lights are on but nobody’s home.
NF980-G65
Phenom ll x4 965 Black
4gb DDR3 CL9 Kingston 1333mhz
MSI N465GTX (OC to 470 Specs)
PSU OCZGXS850
500 gb SATA ll Seagate HDD
Sony DVD
Well first unplug everything but the power connections,CPU,RAM. I assume you are using aftermarket vid or onboard vid. Make sure the power to the vid is plugged in right. Then start. if that doesnt work, post back here and we can go to the next step.
Hi Jason
Thanks for your input. I did what you said and it booted to post. Now I’m just tweaking everything up. For a while I thought a piece of hardware or a short at the MB / Case was at fault and I would have to start from scratch again. But as it happened I disconnected all the hardware pulled the ram and moved one stick to another channel and away it went. So thanks for help.
Ron
This may be a dead subject…but after having this board for months it has started not posting. I have to turn the power on….wait a few seconds then hit the reset button…sometimes 2-3 times before it posts….sooo frustrating.
Finally I just bought the crosshair extreme. Im in a jam because I have the AMD 1090T and two GTX580’s…tough to find an AMD board that supports SLI.
here is my rig http://www.youtube.com/watch?v=35g_mnlG0ME
How is this board still running for you? I have heard that it has its faults and quite a few of them actually POP* and generate smoke/sparks when overclocked.